HF cable BNC-BNC

The cable is used to hang calibration oscillator to the transceiver’s antenna jack.

Short high-frequency cable of 30 cm length with the BNC connectors at the ends is used during the device’s calibration. It is very comfortable to use this accessory in aggregation with handy calibration oscillator. Calibration of the device usually lasts for some minutes.

Note: Expert Electronics uses high frequency connectors BNC in its devices. It is not desirable to attach devices to connectors of USSR (type “Bayonet”), because it can bring to their destruction.

It is recommended to use corresponding mates of BNC type!